Primary construction activities for the week of 07/01 thru 07/05 will consist of the following:

|   * = Start or Finish was delayed    |   ** Activity taking longer than projected   |

• ROOFING
• Low Roof Auditorium:
  • Start installing roof
• Lab Wing Main Roof:
  • Continue installing hot fluid-applied rubber asphalt (tying to exterior walls)
• Penthouses:
  • Installing water barrier
• Lab High Roof West:
  • Continue installing roof

 

• FRAMING SHEATING (2^nd & 3^rd Floor)
• Lab Wing – South Elevation:
  • Finish installing temp window protection (if needed) *

 

• FRAMING SHEATING (1^st Floor)
  • Lab Wing – South Elevation:
• Installing window steel at head & sill, flashings, and air & water barrier

• Auditorium – North Elevation:
  • Finish installing steel studs
  • Start installing exterior gyp
• Auditorium – East Elevation:
  • Start installing flashings, window steel, and temp window protection (if needed)
    • Auditorium – South Elevation:
  • Continue installing air & water barrier, window steel, and flashings **
• Auditorium – West Elevation:
  • Finish installing steel studs **
  • Start installing exterior gyp *

 

• WINDOWS & SIDING
• Lab Wing – West Elevation:
  • Continue installing vertical wood cladding
• Lab Wing – North Elevation:
  • Continue installing vertical wood cladding and windows

 

 

 

 

• Lab Wing – East Elevation:
  • Finish installing horizontal cleat (pulled off to go to South side) *
  • Installing flashings and trim
  • Start installing backer rod and caulk and vertical wood cladding *
• Lab Wing – South Elevation:
  • Continue installing windows, flashings & trim, and horizontal cleat
• Auditorium – East Elevation:
  • Start installing windows and vertical Z girt
• Auditorium – South Elevation:
  • Continue installing vertical Z girt

 

• INTERIOR BUILDOUT
• Mechanical & Back of House:
  • Finish installing gyp top out & electrical rooms, tape & finish one side top out, stuffing and spraying for STC’s, sound board at OTS ceilings, and extending down rods
• Lab Wing Level 2 – Rough-in:
  • Finish installing gyp top out one side of walls at duct locations
  • Continue installing MEP in Labs
  • Start tape and finish one side top out

 

• SITE IMPROVEMENTS
• Mechanical Enclosure M0101:
  • Setting Generator and ACCH-101

 

• ODF&W Parking and Sidewalks:
  • Start installing rebar for sidewalks and mono curbs *
  • Excavating for Rain Garden #2 *